Crush Guard - User - Pre Operation Checks
Run through the tests below before operating the machine.
The procedure below tests the cutout and override mechanism of the Crush Guard®:
These tests must be performed in addition to the pre
operation checks listed in the machine operator manual
Related Articles
Gen3 - User - Pre Operation Checks
These tests must be performed in addition to the pre-operation checks listed in the machine operator manual The EQSS Gen 3 system monitors the machine operating conditions via its own Gen 3 system sensors and then creates cutouts when it deems that ...OverWatch - User - Pre Operational Checks
The OverWatch™ is an electronic detection system and is an aid to the operator. Before use, make sure that the system is in good working condition. Conduct the following pre-operation checks.Crush Guard - User - Crush Guard Reset Procedure
When the Crush Guard® alarm is triggered Follow the steps below to reset the system: 1. Ensure the magnet is attached, as shown in picture - highlight circle 1 2. Press the Reset button to disable the alarm and return to normal operation - highlight ...Crush Guard - User - Operating The System
The Crush Guard® is designed to cut off the EWP movement when an object impacts the operator from above or behind - and they fall over the controls. The Crush Guard consists of a mechanical frame that runs a wire rope over the operator controls. In ...Crush Guard - General - What is Crush Guard?
The EQSS Crush Guard is a secondary guarding solution designed in Australia for use with elevated work platforms (EWP). The Crush Guard uses a pressure sensitive wire rope positioned over the EWP controls. When a crushing incident occurs (forcing the ...