Gen3 - Software - Enable and Setup Height Limiter

The height limiter function in the Gen3-LMS is only compatible with certain machines. To determine if the machine supports the height limiter function goto System Menu -> System Tests and enable the Boom Raise Cutout and Boom Extend Cutout and see if these boom functions are restricted. If these cutouts work then the machine is compatible with the height limiter function.
Follow the instructions below to configure the Gen3-LMS can be configured to limit the boom maximum height.
- Download and install Notepad++ from this link
- Remove the SD card from the Gen3 display and insert into a laptop
- Open the file data.cfg using Notepad++
- In the top [General] section update the following values
HeightLimitEnabled=1 ; Enable Height Limit Function (0 to disable)
HeightLimitSetPoint=2000 ; Height Limit in millimeters (eg. 2000mm) - Save the file
- Click Safely Remove Hardware from the system tray to safely remove the SD card from the laptop
- Insert the SD card into the Gen3 display
- Test the height limit set point

The Gen3-LMS will engage the height limit cutout once it reaches the configured set point. The entered set point value should be less than the required height limit to allow for overshoot. The faster the boom moves the lower the set point value should be in order to stay below the height limit requirement.

Do not edit anything else in the data.cfg except the lines as instructed above. Modifications to the Gen3 configuration files may cause the Gen3 to exhibit unknown or unpredictable behaviour negating the safety function.
Related Articles
Gen3 - User - Height Limiter & Sloping Terrain Operation
The Gen-3 safety system has the ability to limit the maximum height of the boom This ensures the machine operates below a pre defined height limit threshold. This is useful when the machine is operating under power lines or inside a tunnel. When the ...
Gen3_ITC - Software - EQSS Gen 3 Configuration Tool
All end user capable configuration tasks are accomplished using the EQSS Gen 3 Configuration Tool The EQSS Gen 3 Configuration Tool is part of, and is automatically downloaded when the EQSS software suite is downloaded. The EQSS: Gen 3 Configuration ...
Gen3 - Software - EQSS Gen 3 Configuration Tool
All end user capable configuration tasks are accomplished using the EQSS Gen 3 Configuration Tool The EQSS Gen 3 Configuration Tool is part of, and is automatically downloaded when the EQSS software suite is downloaded. The Tech Doc -- Gen3 - ...
Gen3 - Selections - Disable/Enable Forward/Reverse Camera (Old Display Software)
Enabling/disabling cameras in older Gen 3 display software can be done by directly editing a configuration file on the SD card Enabling/Disabling cameras in older display software versions requires a PC/Laptop, an SD card reader and the Windows ...
Gen3 - Software - Telehandler and ITC Operating Systems are different
The Gen-3 Configuration Tool can be used to Upload the Emtrion or Toradex Operating System EQSS ships the Gen 3 Display with two different Operating Systems; intended for two different and incompatible purposes. One Operating System is only used with ...