Gen1 - Software - Set to Manual Tool Selection
Your Gen1 Safety System Can Operate On Manual Tool Selection
To enable Manual tool selection.
1. Remove the Compact Flash Dist from the display and open the disk on a computer
2. Open the folder CONFIG
3. Inside this folder there is a file called TELE.INI Open this file with notepad.
4. In the file you will see a section called [GENERAL] as shown below
1. Remove the Compact Flash Dist from the display and open the disk on a computer
2. Open the folder CONFIG
3. Inside this folder there is a file called TELE.INI Open this file with notepad.
4. In the file you will see a section called [GENERAL] as shown below
[GENERAL]
ENA=+00000
5. Change the ENA=+00000 to ENA+00001 (ie change the last zero to a 1) as shown below
[GENERAL]
ENA=+00001
6. Save this file.
7. Eject the flash card and put it back in the display.
8. You will now be able to select the tool manually using the switch in the cabin to scroll through the tools