Gen1 - User - Cut Out

Gen1 - User - Cut Out

Cut-out Operation
When the cut-out is engaged, the general stop indicator will show on the display.
If the LED bar graph is unlit when the cut-out is engaged; this indicates that the currently identified attachment can't be used in this configuration.

Cut-out Override
When the cut-out is engaged, turn and hold the override key switch to override the cutout. Release the override key switch for normal operation.

Emergency override switch


Maximum Angle Overload Protection
To prevent over-pressuring the counterbalance valve and triggering a false cutout, the boom angle is limited to 1-2 degrees below its maximum angle. Once the boom has reached it's maximum angle the boom must be lowered by 3-4 degrees before it can be raised again.

    • Related Articles

    • Gen3_ITC - General - What is a GEN 3 ITC?

      This system has been designed specifically for use with Integrated Tool Carriers (ITC) to cover all relative national and international safety standards. This Tech Doc details system specifications, system functionality, installation requirements, ...

    • Gen1 - User - Troubleshooting

      Troubleshooting Common EQSS Gen 1 Problems Problem: The boom won't move and the stop icon is showing on the display Solution: You are trying to lift a load which is greater than the maximum capacity specified by the manufacturer rating charts for ...

    • Gen3_ITC - User - Gen 3 Menu System

      The menu system allows for configuring the Gen-3 system To enter the menu system, press the user control dial. This will display the main menu. To navigate through the menu options press the arrow buttons on the user control dial. The currently ...

    • Gen3 - User - Gen 3 Rating Chart Window

      The rating chart window displays the current rating chart for the selected attachment and the stabilizer configuration. The load segments on the rating chart are color coded to match the current load. If the segment is green and the boom was moved ...

    • Gen1 - Installation Deici Icarus 40.17 Gen 1 to Gen 3 - User Input Control

      The user input control switch is used to navigate the menus in the Gen3 LMS The user input control should be mounted in the dashboard in a location that is usable and visible to the operator. Drill a 34 mm hole into the dashboard to mount the switch. ...