Gen3 - Attachments - Winches

The rating chart shows the maximum load rating for the boom location with the winch hook block - fully retracted.

Most rating charts decrease the rating as the boom is raised higher. The load rating will remain the same even if the hook block is lowered into a higher load capacity band (since the boom is still at the same height). 

• Related Articles

• Gen3 - Attachments - Gen 3 LMS Fork Attachments

  As far as the Gen 3 LMS system is concerned, all fork attachments are not the same During normal telehandler operation, the Gen 3 LMS system monitors varying hydraulic pressure (via the four pressure sensors) to calculate telehandler lifted weights. ...

• Gen4 - Attachments - Specific Attachments

  There are special use cases to be aware of when using specific types of attachments with the Gen4-LMS system. Please be aware of the following: Long Reach Attachments When using attachments that have a long reach such as a long boom or fly jib/winch, ...

• Gen3 - Attachments - Gen 3 LMS Compatible Attachments Lists

  The Gen 3 system software already contains a large selection of instantly usable attachments for supported telehandlers As can be appreciated, the marketplace has many machine attachment manufacturers. Each of these manufacturers has available a ...

• Gen3_ITC - Attachments - Long Reach Attachments

  When using attachments that have a long reach such as a long boom or fly jib/winch, the attachment can only be used in a horizontal position. Below: Example of a long reach attachment Since there are no sensors on the tilt head, the Gen-3 assumes the ...

• Gen3 - Attachments - Attachments Lists and Load Charts

  Attachment Lists containing calibrated load charts are available to view on the EQSS website. Navigation Path = EQSS Main Page -> Products -> GEN3-LMS -> Attachments Then select the brand (JCB, Manitou...etc) Find the machine model that's relevant to ...