T05

Gen3 - Fault Code - T05

This fault code can appear when the Gen 3 is not able to write to the SD card. 

There are two common causes for this error code:
1. Write Lock Tab on the SD card has been set to 'Locked'.
2. SD card carrier in the EQSS Display unit is faulty.

Remedies:
1. Power off the Gen 3 system. Take the card out of the display carrier, then slide the write protect tab to the unlocked position. Reinsert the SD card into the display SD card slot and power up the Gen 3 system.
2. If the action in remedy 1 doesn't remove the T05 fault, raise an EQSS support request and then send the display unit back to EQSS for diagnosis/repair.

    • Related Articles

    • Gen3 - Fault Code - All Gen 3 Fault codes

      Gen 3 Fault codes are displayed in Red color and are displayed in the same - on screen section as the 'Attachment' field On screen Fault codes location. Fault and fault codes are only displayed if a fault has actually occurred (blank normally). To ...

    • Gen3 - Fault Code - T01

      This fault code can appear when a component of the Gen 3 system has been replaced and/or reprogrammed (usually the CSDM display). The remedy that usually clears this fault is the re-calibration of the boom angle. To achieve this task requires the ...

    • Gen3 - Fault Code - T03

      This fault code can appear when a component (CPIM) of the Gen 3 system has been replaced/moved and can sometimes be intermittent during telehandler operation with shifting weight. The remedy that usually clears this fault is the re-calibration of the ...

    • Gen3 - Fault Code - T02

      This fault code can appear when a component of the Gen 3 system has been replaced and/or reprogrammed. The remedy that usually clears this fault is the re-calibration of the boom length. To achieve this task requires the operator to navigate the Gen ...

    • Gen3 - Fault Code - T14

      This fault code can appear with a fresh Gen 3 install or when a CCIM has been replaced. The EQSS CCIM uses PCB mounted DIP switch banks for forward/reverse telehandler drive logic settings. These settings are configured at the factory and can be ...