Gen3 - General - High Pressure Washing
Do NOT high pressure clean any EQSS Gen 3 components as this will void your warranty.
High pressure cleaning is only possible on IP-69 (and above) rated items. None of the EQSS components are rated to IP-69.
IP ratings for EQSS components:
6202 CSDM (Display Unit) = IP-54
6259 CCIM = IP-65
6258 CPIM = IP-67
6206 CALM (Cable Reeler) = IP-64
6231 CLTM (Light Tower) = IP-64
Third Party Supplier
OP001028 Gen 3 - Rear Camera = IP-67
OP001029 GEN3 - Forward Camera = IP-67
As can be seen, these cameras and all of our components are not high pressure cleaner proof nor even high pressure cleaner resistant. This is the reason that we provide 'No High Pressure Washing' sticker labels on all of our weather bearing gear.
If you absolutely must high pressure clean your ITC/Telehandler then please avoid pressure cleaning the installed EQSS Gen 3 components.
Water ingress on a Gen 3 component from a high pressure cleaner will render your safety system unreliable, thereby negating it's purpose and shall absolutely void your warranty.
Related Articles
Gen4 - General - What is Gen 4 LMS?
What is it? The Gen 4 system was conceived as a joint venture between EQSS and Haulotte France. It was an evolutionary product that was intended to populate the next generation of Haulotte telehandlers. It featured the EQSS exclusive BPS sensor. The ...Gen3 - Installation - Can Pressure Input Module (CPIM)
The CPIM is responsible for processing the information sent from the pressure sensors and also measures the carrier attitude (telehandler chassis angles). The CPIM is mounted on the chassis and must be mounted with the five M12 screw lock connectors ...Gen3 - Installation - Generic Main Pressure Sensor Installation
The hydraulic pressure sensors are used to measure the lifting load of the telehandler. There are two main pressure sensors that need to be mounted to measure the pressure in the main lift cylinder - Main Head and Main Rod. Main Head Pressure The ...Gen3 - Hardware - Troubleshooting Pressure Switch/CAN Bus Cables and Connectors
The EQSS Pressure Switch cable has 4 conductor cores and is the same cable that's also used for the EQSS CAN connections The EQSS name and part number for this cable are: GEN-3 Pressure Sensor/CCIM->CPIM Cable (PN: CB001026) The cable is molded and ...Gen1 - Installation Deici Icarus 40.17 Gen 1 to Gen 3 - Pressure Sensor Installation
The hydraulic pressure sensors are used to measure the lifting load of the telehandler. There are two pressure sensors that need to be mounted to measure the pressure in the main lift cylinder. The pressure sensors from the GEN1 will need to be ...