Gen3 - General - Jump Start Safety Information

Gen3 - General - Jump Start Safety Information

Only Jump Start Machine using a Floating Battery
Connect a floating battery of the same type and voltage to the machine by following the instructions in the machine operator manual. 

If a floating battery is NOT available then disconnect Gen3-LMS before Jump Start Machine
Before jump starting the machine ensure the 26 and 34 pin black bulkhead mount connections are removed from the CCIM (installed under the covers inside the cabin). Otherwise the sensitive electronics in the Gen3-LMS system may be damaged from the power surge - thereby negating the protection of the system.

Photo showing the 26 and 34 pin black bulkhead mount connections removed during jump start


    • Related Articles

    • ITC SWL- Safety - Jump Starting

      Please heed the warning below when jump starting the vehicle Only Jump Start Machine using a Floating Battery – Connect a floating battery of the same type and voltage to the machine by following the instructions in the machine operator manual. If ...

    • Gen4 - General - Gen 4 Components Outline

      Hardware Overview Display The Model 6205 Display Module is the main HMI device for the Gen4-LMS. It is used to display information to the operator. It contains a built in touch screen to allow the operator to interact with the system, and dual audio ...

    • Gen4 - General - Identification Of Safety Functions

      The main purpose of the Gen4-LMS is to engage a safety cutout when the machine is lifting a load which is beyond the capabilities of the machine for the current boom position. The safety cutout will activate in either one of two ways: Using a relay, ...

    • Gen3 - Fault Code - All Gen 3 Fault codes

      Gen 3 Fault codes are displayed in Red color and are displayed in the same - on screen section as the 'Attachment' field On screen Fault codes location. Fault and fault codes are only displayed if a fault has actually occurred (blank normally). To ...

    • Gen3 - General - High Pressure Washing

      Do NOT high pressure clean any EQSS Gen 3 components as this will void your warranty. High pressure cleaning is only possible on IP-69 (and above) rated items. None of the EQSS components are rated to IP-69. IP ratings for EQSS components: 6202 CSDM ...