Gen3 - General - Installation Requirements (Skills)

The Gen3 LMS requires the following competent technical skills to complete the installation 

Skills Required

1. Workshop Mechanic – The Gen3 LMS requires mounting external sensors on the telehandler. This may require the manufacture and fabrication of custom brackets, to correctly mount the sensors in the required orientations. It may also require drilling and tapping holes - or welding to mount the sensors.
   

1. Hydraulic Technician – The load measurement system of the Gen3 LMS requires the use of pressure sensors in the main lift cylinder. This may require sourcing hydraulic fittings, or modifying existing hydraulic components to fit the pressure sensors.
   

1. Automotive Electrician – The Gen3 LMS requires power from the telehandler electrical system, as well as input from some of the cabin controls (such as the drive direction and stabilizer states). The switch signal directions may require the installation of reversing diodes in the wiring harnesses to ensure correct switching inputs. It is strongly recommended that the services of a qualified automotive electrician be contracted for all electrical tasks.
   

Please remember that this is a safety system and correct reliable installation techniques are critical for reliable operation.

• Related Articles

• Gen3_ITC - Installation - Installation Requirements (Skills)

  The Gen3 LMS ITC requires the following technical skills to complete the installation Skills Required Workshop Mechanic – The Gen3 LMS requires mounting external sensors on the telehandler. This may require the manufacture and fabrication of custom ...

• Gen3 - General - Gen 3 Kits are Sold Machine Specific

  EQSS Gen 3 kits are Engineered, built, configured and sold as machine serial number specific orders The purpose for this Tech Doc is to briefly describe the Engineering Process that is implemented at EQSS for kits that will be fitted to recently ...

• Gen3 - Installation - Generic Gen 3 LMS Schematics

  The Schematics below can be used to help with diagnosing EQSS Gen 3 LMS wiring faults on a Telehandler Generic Gen 3 LMS Schematics CCIM Connections Connector CN01 = Camera/Power Port Connector CN02 = I/O Port

• Gen4 - General - What is Gen 4 LMS?

  What is it? The Gen 4 system was conceived as a joint venture between EQSS and Haulotte France. It was an evolutionary product that was intended to populate the next generation of Haulotte telehandlers. It featured the EQSS exclusive BPS sensor. The ...

• Gen3 - Installation - Cable Reeler Installation (General Guidelines)

  The cable reeler contains the sensors required to measure the boom extension and boom angle - to allow the Gen3 LMS to calculate the boom position. Installation Steps: 1. The cable reeler must be installed at the end of the boom - as close to the ...