Gen3_ITC - Attachments - Automatic Recognition
When the Gen-3 system is configured for automatic tool selection, the system will read the
identification tag on the attachment and automatically change the system to the matching
attachment.
If the attachment has multiple configurations (e.g multiple knuckle positions), the attachment
selection menu will be shown to select the correct configuration. To change the selected
configuration, access the attachment selection menu.
If the machine has multiple attachments without identification tags, the attachment
selection menu will be shown if an attachment can't be identified.
When using automatic tool selection the attachment window may show the following
messages:
• No Attachment – There is currently no attachment on the ITC or the system can't
find the identification tag.
• Attachment Not Calibrated – The Gen-3 system has recognised an attachment but
the system has not yet been calibrated for the attachment.
• Unknown Attachment – The Gen-3 system has read an identification tag that is not
in the system.
When any of the above messages are shown, no visual rating chart is shown on the
screen and the system is de-rated to 80% of the standard fork rating charts.
If the current attachment has multiple configurations the
attachment selection menu will be shown to select the
configuration when the system starts
Related Articles
Gen3 - Attachments - Attachment Automatic Recognition
When the Gen-3 system is configured for automatic tool selection, the system will read the identification tag on the attachment and automatically change the system to the matching attachment. If the attachment has multiple configurations (e.g. ...
Gen3 - Attachments - Change Between Automatic & Manual Tool Selection
Changing settings via the display was added in Display Version 1129. Check the current display version in the Status Menu. If the version is older then follow the instructions here to update the display. Press Enter on the user control dial to enter ...
Gen3 - Attachments - Update Existing Gen3-LMS for New Attachments
Adding a new attachment to an existing telehandler with a Gen3-LMS system requires an update to the model configuration. To perform the update a laptop with an SD card reader and internet connection is required. The below needs to be performed ...
Gen3 - Selections - Disable / Enable Auto Tool Recognition
Changing settings via the display was added in Display Version 1129. Check the current display version in the Status Menu. If the version is older then follow the instructions here to update the display. Press Enter on the user control dial to enter ...
Gen3_ITC - User - Understanding the Screen Layout
The user display consists of a 7 inch wide screen high definition, Sunlight readable, TFT display. All principle ITC operating data is displayed on the EQSS Gen 3 main screen. The user display provides the following real time information: Boom angle ...