Gen3_ITC - Fault Code - IN09

Gen3_ITC - Fault Code - IN09

Notes
The ITC machines use an articulation sensor to monitor the articulation of the vehicle
The following are possible reasons:
  1. CPIM Articulation Fault
  2. The 'articulation angle sensor' is not recognised.
Troubleshooting:
  1. The articulation sensor is connected to the EQSS system via a cable. Please check for breaks or cuts in that cable.
  2. The articulation sensor is mounted on an articulation sensor assembly and the articulation sensor is mechanically adjustable. Please refer to the installation manual for your particular machine for further assembly details and adjustments.
  3. Articulation sensor could be faulty.
InfoIf you suspect a faulty articulation sensor or damaged sensor cable, contact EQSS to order a replacement.

    • Related Articles

    • Gen3_ITC - Fault Code - All Gen 3 Fault codes

      Gen 3 Fault codes are displayed in Red color and are displayed on the Gen 3 operator screen To further identify the fault (via the Gen 3_ITC Display), enter the Menu System, then select System Faults. This will display a list of the current system ...

    • Gen3_ITC - Fault Code - IT05

      This fault code can appear when the Gen 3 ITC is not able to write to the SD card. There are two common causes for this error code: 1. Write Lock Tab on the SD card has been set to 'Locked'. 2. SD card carrier in the EQSS Display unit is faulty. ...

    • Gen3_ITC - Fault Code - IT09

      This fault code can appear with a fresh Gen 3 install or when a CCIM has been replaced. The EQSS CCIM uses PCB mounted DIP switch banks for forward/reverse ITC drive logic settings. These settings are configured at the factory and can be ITC ...

    • Gen3_ITC - Fault Code - IT02

      The EQSS Gen 3 ITC kit contains a sensor that monitors the vehicle articulation angles The Gen 3 articulation angle sensor is used by the EQSS system to gather vehicle articulation data as part of the machine's weight lift capacity calculations. If a ...

    • Gen3_ITC - Fault Code - IT01

      Boom Angle is calibrated during the initial kit install The Boom Angle Sensor is used to determine the inclination of the boom relative to the initially calibrated machine angle. The IT01 fault code signifies: Boom Angle Out of Range The boom angle ...