Gen3_ITC - Fault Code - IT05
This fault code can appear when the Gen 3 ITC is not able to write to the SD card.
There are two common causes for this error code:
1. Write Lock Tab on the SD card has been set to 'Locked'.
2. SD card carrier in the EQSS Display unit is faulty.
Remedies:
- Power off the Gen 3 ITC system. Take the card out of the display carrier, then slide the write protect tab to the unlocked position. Reinsert the SD card into the display SD card slot and power up the Gen 3 system.
- If the action in remedy 1 doesn't remove the IT05 fault, raise an EQSS support request and then send the display unit back to EQSS for diagnosis/repair.
Related Articles
Gen3_ITC - Fault Code - All Gen 3 Fault codes
Gen 3 Fault codes are displayed in Red color and are displayed on the Gen 3 operator screen To further identify the fault (via the Gen 3_ITC Display), enter the Menu System, then select System Faults. This will display a list of the current system ...Gen3_ITC - Fault Code - IT09
This fault code can appear with a fresh Gen 3 install or when a CCIM has been replaced. The EQSS CCIM uses PCB mounted DIP switch banks for forward/reverse ITC drive logic settings. These settings are configured at the factory and can be ITC ...Gen3_ITC - Fault Code - IT02
The EQSS Gen 3 ITC kit contains a sensor that monitors the vehicle articulation angles The Gen 3 articulation angle sensor is used by the EQSS system to gather vehicle articulation data as part of the machine's weight lift capacity calculations. If a ...Gen3_ITC - Fault Code - IT01
Boom Angle is calibrated during the initial kit install The Boom Angle Sensor is used to determine the inclination of the boom relative to the initially calibrated machine angle. The IT01 fault code signifies: Boom Angle Out of Range The boom angle ...Gen3_ITC - Fault Code - IN06
The CDAM is a CAN bus device and it passes ITC arm/boom angle information to the rest of the EQSS system The Boom Angle Sensor is used to determine the inclination of the boom relative to the initially calibrated machine angle. Some possible reasons ...