Gen3_ITC - Installation - Caterpillar 962K Boom Angle Sensor Installation
The Boom Angle Sensor is used to determine the inclination of the boom relative to the
initially calibrated machine angle
Installation Steps:
1. Drill two M6 holes for the Angle
Sensor in the position on the inside
of the arm in the location shown in
the diagram.
2. Mount the angle sensor using the
supplied M6 bolts, with the M12
connector facing downwards.
3. Attach the 4 way M12 cable to the
sensor and route the cable to the
CPIM using an appropriate wire path,
using cable ties to secure the cable.
Related Articles
Gen3_ITC - Installation - Volvo L120H & L90 Boom Angle Sensor Installation
The Boom Angle Sensor is used to determine the inclination of the boom relative to the initially calibrated machine angle. Installation Steps: 1. Drill two M6 holes for the Angle Sensor in the position on the arm Shown in the diagram. 2. Mount the ...Gen3_ITC - Installation - Caterpillar 962K Pressure Sensor Installation
The hydraulic pressure sensors are used to measure the lifting load of the ITC Main Cylinder Installation Steps: 1. Raise the boom to approximately 40 degrees. Support and secure the boom using an A Frame or similar apparatus. It must support at ...Gen3_ITC - Installation - Caterpillar 962K Articulation Sensor Installation
The articulation sensor is mounted mid machine at the point of machine articulation Installation Steps: 1. Install the Articulation base plate in the location shown (red circle in the left photo below). Make sure the inner circle from the ...Gen3_ITC - General - What is a GEN 3 ITC?
This system has been designed specifically for use with Integrated Tool Carriers (ITC) to cover all relative national and international safety standards. This Tech Doc details system specifications, system functionality, installation requirements, ...Gen3_ITC - Calibration - Determining Boom Angle Zero on ITC
When calibrating the boom angle on an ITC for the Gen3-LMS, the boom must be raised up 0 degrees. For an ITC the boom angle is at 0 degrees when the boom/chassis pivot pin and boom/head pivot pin are at the same height off the ground. Move the ITC to ...