Gen3_ITC - Installation - Caterpillar 962K Cabin Loom Installation

Gen3_ITC - Installation - Caterpillar 962K Cabin Loom Installation

Notes
The cabin loom connects the CCIM to the machine connections and the other modules of the system
Installation Steps:
1. Connect the power/camera and IO harnesses to the CCIM bulk head connectors.


2. Connect the ‘Signal Light’ cable and CPIM cable to either of the M12 connector on the CCIM.


3. Connect the 8 pin ‘CCIM to display’ cable and the 5 pin ‘User Control’ cable to the 8-pin and 5 pin connectors on the back of the display.


4. Install the Override button in the location shown in the images below.
  
Warning
Do not disconnect the camera power connection while the system is operating as this can damage the fuse





    • Related Articles

    • Gen3_ITC - Installation - Volvo L120H & L90 Cabin Loom

      The cabin loom connects the CCIM to the machine connections and the other modules of the system 1. Connect the power/camera and IO harnesses to the CCIM bulk head connectors. 2. Connect the reverse camera and remote camera connectors to the ...
    • Gen3_ITC - Troubleshooting - Troubleshooting the Caterpillar 962K ITC

      Gen 3_ITC List of problems and Solutions on a Caterpillar 962K Problem: The boom won't raise and the cutout icon is showing on the display Solution: You are trying to lift a load which is greater than the maximum capacity specified by the ...
    • ITC SWL- Hitachi & JCB - Cabin Electronics Installation

      The cabin electronics interface into the load sensor and produce the required cutout. Installation Steps: Install the indicator and override switch into a two spare housing in the dashboard. Below: Overload Indicator & Override Switch The switch ...
    • Gen3_ITC - Installation - Caterpillar 962K Signal Light Installation

      The signal light warns other workers when the ITC is lifting loads close to it's maximum capacity Installation Steps: 1. Drill and tap four M4 holes to mount the signal light bracket to the left side of the cabin roof (location shown in the photo). ...
    • Gen3_ITC - Installation - Caterpillar 962K Display Installation

      The display shows the current safety status of the ITC Installation Steps: Position the display bracket at the top left of the Switch Column. Drill two M6 holes to attach the bracket to the Switch Column. Secure the bracket to the switch column using ...