Gen3_ITC - Installation - Caterpillar 962K Display Installation

Gen3_ITC - Installation - Caterpillar 962K Display Installation

Notes
The display shows the current safety status of the ITC
Installation Steps:
  1. Position the display bracket at the top left of the Switch Column.
  2. Drill two M6 holes to attach the bracket to the Switch Column.
  3. Secure the bracket to the switch column using the supplied large washers and nuts.
  4. Attach the display to the bracket and tighten the grub screw.
   

Info
Adjust the display bracket for optimal viewing angle once the display is powered

Warning
If the M12 screw lock connectors on the display are over tightened it will twist the connector pins attaching the connector to the PCB.  This could create a short between the pins or even break the solder joints.