Gen3_ITC - Installation - Caterpillar 962K EQSS CCIM Module Installation

The CCIM connects the system into the machine electronics

Installation Steps:

1. Mount the backup battery in the location (shown in the diagram below) using the double sided velcro tape attached to the base. 

2. Slide the CCIM in the location shown in the photo below.

3. The Connectors will then be attached to CCIM once the harnesses are installed.

• Related Articles

• Gen3_ITC - Software - EQSS Gen 3 Configuration Tool

  All end user capable configuration tasks are accomplished using the EQSS Gen 3 Configuration Tool The EQSS Gen 3 Configuration Tool is part of, and is automatically downloaded when the EQSS software suite is downloaded. The EQSS: Gen 3 Configuration ...

• Gen3_ITC - Installation - Volvo L120H & L90 EQSS CCIM Installation

  The CCIM connects the system into the machine electronics Installation Steps: 1. Mount the backup battery in the location shown in the diagram using the double sided velcro tape attached to the base. 2. Slide the CCIM in the location shown in the ...

• Gen3 - Software - EQSS Gen 3 Configuration Tool

  All end user capable configuration tasks are accomplished using the EQSS Gen 3 Configuration Tool The EQSS Gen 3 Configuration Tool is part of, and is automatically downloaded when the EQSS software suite is downloaded. The EQSS: Gen 3 Configuration ...

• Gen3 - Installation - Generic Can Cabin Interface Module (CCIM)

  The CCIM connects the system into the machine electronics and interfaces between the display and the external sensors. The CCIM along with the backup battery (see Note 1.) should be mounted inside the dashboard, near the rest of the machine ...

• Gen3_ITC - Troubleshooting - Troubleshooting the Caterpillar 962K ITC

  Gen 3_ITC List of problems and Solutions on a Caterpillar 962K Problem: The boom won't raise and the cutout icon is showing on the display Solution: You are trying to lift a load which is greater than the maximum capacity specified by the ...