Gen3_ITC - Installation - Caterpillar 962K Machine Connections

Gen3_ITC - Installation - Caterpillar 962K Machine Connections

Notes
This Tech Doc describes how to connect the safety systems to the existing electronics in the machine
Installation Steps:
1. Locate the system power lug (Constant 24V). Attach the power wire (yellow) from the 24V to 12V converter to the ring lug.


2. Locate the system ground lug Attach the ground wire (black) from the 24V to 12V converter to the ring lug.


3. Locate the accessories (signal) wire (24V when machine is switched on, 0V when machine is off). Cut and Splice the wire attached to the terminal with the ‘24V to 12V converter’ signal wire (Purple).


Notes
Some machines had wiring modifications applied by the end user and may not match the wiring in this Tech Doc
Warning
Isolate the main battery before starting the machine connections
Warning
After completing the machine connections the boom can not be moved until the installation is complete 
 
    • Related Articles

    • Gen3 - Installation - Generic Machine Electrical Connections

      To accommodate the various brands and many models, a substantial number of Gen 3 installation kits have been engineered and are available for purchase from EQSS. The following sections serve to illustrate common electrical connections from the Gen 3 ...
    • Gen3_ITC - Installation - Volvo L120H & L90 Machine Connections

      This Tech Doc describes how to connect the safety systems to the existing electronics in the machine To complete all of the steps within this Tech Doc, you should either be an auto electrician or have the services of an auto electrician. EQSS accepts ...
    • Gen4 - Installation - Haulotte HTL 4014 Machine Connections

      The following procedures connect the safety systems to the existing electronics in the machine Installation Steps: 1. Isolate the machine before continuing to avoid damage to the electronic modules. 2. Locate the connector CN08 which can be found ...
    • Gen4 - Installation - Haulotte HTL 4017 Machine Connections

      The following procedures connect the safety systems to the existing electronics in the machine Installation Steps: 1. Isolate the machine before continuing to avoid damage to the electronic modules. 2. Locate the connector CN08 which can be found ...
    • Crush Guard - Installation - Haulotte Star10 Machine Connections

      This Tech Doc shows how the Machine Connections are completed Installation Steps: 1. Remove the 4 bolts that secure the lid to the operator control box. 2. Drill a 20 mm hole in the location marked earlier for the M23 connector. 3. Insert the ...