Gen3_ITC - Installation - Volvo L120H & L90 CPIM Installation
The CPIM is responsible for processing the information sent from the pressure sensors, the
articulation sensor and the RFID sensor.
The CPIM also measures the chassis pitch and
roll with its internal angle sensors.
Installation Steps:
1. Drill two M8 holes for the CPIM
bracket in the position of the chassis (Shown in the diagram).
Ensure when marking mounting
location that there is enough room to
connect the cables.
Mount using the supplied
M8 bolts, nuts and washers.
2. Connect the cables for the pressure
sensors, Articulation sensor and
Angle sensors to the CPIM (according
to the picture shown below).
It would be beneficial to use a spirit level on top of the CPIM so that the CPIM module can be mounted square. This is helpful for when later on the sensor calibrations are completed.
Related Articles
Gen3_ITC - Installation - Volvo L120H Main Head & Rod Pressure Sensors
The hydraulic pressure sensors are used to measure the lifting load of the ITC Installation Steps: Completely lower the boom. Apply the handbrake and insert chock under wheels. Once lowered, release any residual pressure by pulling on the manual ...Gen3_ITC - Installation - Caterpillar 962K EQSS CPIM Installation
The CPIM is responsible for processing the information sent from the pressure sensors the articulation sensor and the RFID sensor The CPIM also measures the chassis pitch and roll with its internal angle sensors. Installation Steps: 1. The location ...Gen3 - Installation - Can Pressure Input Module (CPIM)
The CPIM is responsible for processing the information sent from the pressure sensors and also measures the carrier attitude (telehandler base angles). The CPIM is mounted on the chassis and must be mounted with the five M12 screw lock connectors ...Gen3_ITC - Installation - Volvo L120H & L90 Boom Angle Sensor Installation
The Boom Angle Sensor is used to determine the inclination of the boom relative to the initially calibrated machine angle. Installation Steps: 1. Drill two M6 holes for the Angle Sensor in the position on the arm Shown in the diagram. 2. Mount the ...Gen3_ITC - Installation - Volvo L120H & L90 RFID Reader Installation
The RFID reader is the machine’s communication point for the automated tool recognition system. Installation Steps: 1. Drill two M6 holes in the position shown in the diagram below and install the RFID reader using the supplied M6 screws and washers. ...