Gen3_ITC - Installation - Volvo L120H & L90 Display Installation

Gen3_ITC - Installation - Volvo L120H & L90 Display Installation

Notes
The display shows the current safety status of the ITC.
Installation Steps:
  1. Position the display bracket at the top left of the Switch Column.
  2. Drill two M6 holes to attach the bracket to the Switch Column.
  3. Secure the bracket to the switch column using the supplied large washers and nuts.
  4. Attach the display to the bracket and tighten the grub screw.


Info
Adjust the display bracket for optimal viewing angle once the display is powered 


    • Related Articles

    • Gen3_ITC - Troubleshooting - Troubleshooting the Volvo ITC

      Gen 3_ITC List of problems and Solutions on a Volvo ITC Problem: The boom won't move and the cutout icon is showing on the display Solution: You are trying to lift a load which is greater than the maximum capacity specified by the manufacturer rating ...
    • Gen3_ITC - Installation - Volvo L120H Main Head & Rod Pressure Sensors

      The hydraulic pressure sensors are used to measure the lifting load of the ITC Installation Steps: Completely lower the boom. Apply the handbrake and insert chock under wheels. Once lowered, release any residual pressure by pulling on the manual ...
    • Gen3_ITC - Installation - Caterpillar 962K Display Installation

      The display shows the current safety status of the ITC Installation Steps: Position the display bracket at the top left of the Switch Column. Drill two M6 holes to attach the bracket to the Switch Column. Secure the bracket to the switch column using ...
    • Gen3_ITC - Installation - Volvo L120H & L90 Reverse Camera Installation

      The rear camera video is displayed on the screen when the machine is in reverse gear to allow the operator to see behind the ITC while reversing.Installation Steps: 1. Open the rear panel of the machine and remove the previously existing reverse ...
    • Gen3 - Installation - Generic Display Installation

      The display is the main indicator device for the Gen3 LMS system and should be mounted in a location that is visible to the operator at all times (regardless of the steering wheel and/or seat position). Please refer to the specific EQSS Gen 3 ...