Gen3_ITC - Installation - Volvo L120H & L90 RFID Reader Installation

The RFID reader is the machine’s communication point for the automated tool recognition system.

Installation Steps:

1. Drill two M6 holes in the position shown in the diagram below and install the RFID reader using the supplied M6 screws and washers.

2. Route the hose up the arm back toward the CPIM using cable ties to secure to existing hose routes. The cable will be later attached to the CPIM

• Related Articles

• Gen3_ITC - Installation - Volvo L120H & L90 RFID Tag Installation

  Each tool contains it’s own individual RFID tag, which will communicate with the RFID reader. This installation allows the system to determine which tool is currently active and will outline the location on each tool where the RFID bracket will be ...

• Gen3_ITC - Faults - Debugging RFID Reader

  When automatic tool selection is enabled on the Gen3-LMS, the system uses the RFID reader on the tool coupler and ID tags on the tools to identify the attachment in use. If the tool or attachment is connected to the machine, but the Gen3-LMS is ...

• Gen3_ITC - Installation - Volvo L120H Main Head & Rod Pressure Sensors

  The hydraulic pressure sensors are used to measure the lifting load of the ITC Installation Steps: Completely lower the boom. Apply the handbrake and insert chock under wheels. Once lowered, release any residual pressure by pulling on the manual ...

• Gen3_ITC - Attachments - Automatic Recognition Installation

  ITC AUTOMATIC TOOL RECOGNITION - Installation Instructions Connection Layout: CAN Module Installation: RFID Reader Installation: RFID Tag Installation:

• Gen3_ITC - Troubleshooting - Troubleshooting the Volvo ITC

  Gen 3_ITC List of problems and Solutions on a Volvo ITC Problem: The boom won't move and the cutout icon is showing on the display Solution: You are trying to lift a load which is greater than the maximum capacity specified by the manufacturer rating ...