Gen3_ITC - Installation - Volvo L120H & L90 Signal Light Installation
The signal light warns other workers when the ITC is lifting loads close to it's maximum
capacity.
Installation Steps:
1. Drill and tap four M4 holes to mount
the signal light bracket to the left
side of the cabin roof (as shown in
the photo below).
2. Mount using the supplied M4 bolts
and washers.
3. Making sure that the
top signal light is lower than the
machines roof line.
4. Run the cable through the roof and
feed through the cabin entrance
grommet on the right side of
machine.
5. Ensure that the cable is secured
firmly with cable ties.
6. As the signal light cable is run down
the switch pillar inside the cabin; it
will be run at the same time the
override and camera switches are
installed
Ensure the power supply voltage is greater than 13.5V
otherwise the signal light may not illuminate correctly.
Related Articles
Gen3_ITC - Installation - Caterpillar 962K Signal Light Installation
The signal light warns other workers when the ITC is lifting loads close to it's maximum capacity Installation Steps: 1. Drill and tap four M4 holes to mount the signal light bracket to the left side of the cabin roof (location shown in the photo). ...Gen3_ITC - Troubleshooting - Troubleshooting the Volvo ITC
Gen 3_ITC List of problems and Solutions on a Volvo ITC Problem: The boom won't move and the cutout icon is showing on the display Solution: You are trying to lift a load which is greater than the maximum capacity specified by the manufacturer rating ...Gen1 - Installation Deici Icarus 40.17 Gen 1 to Gen 3 - Signal Light Installation
The signal light warns other workers when the telehandler is lifting loads close to it's maximum capacity. The signal light has a magnet on the base and is designed to be magnetically mounted to the roof of the cabin. Alternatively, the signal light ...Gen3_ITC - Installation - Volvo L120H Main Head & Rod Pressure Sensors
The hydraulic pressure sensors are used to measure the lifting load of the ITC Installation Steps: Completely lower the boom. Apply the handbrake and insert chock under wheels. Once lowered, release any residual pressure by pulling on the manual ...Gen3_ITC - Installation - Volvo L120H & L90 Reverse Camera Installation
The rear camera video is displayed on the screen when the machine is in reverse gear to allow the operator to see behind the ITC while reversing. Installation Steps: 1. Open the rear panel of the machine and remove the previously existing reverse ...