Gen3 - Install - Override Switch for JCB Machines

Gen3 - Install - Override Switch for JCB Machines

Typically when installing a Gen3-LMS kit on a machine, we try to connect into the existing override switch to make it easier and less confusing for the operator.

Unfortunately on the JCB machines the override is integrated into the LMI unit. 
JCB LMI Override Switch
In these circumstances we install a second override switch for the Gen3-LMS into the dashboard.
Gen3-LMS Override Switch


    • Related Articles

    • Gen3_ITC - User - Cutout Override

      The Gen-3 safety system will engage the hydraulic cutout if the ITC is beyond it's recommended capacity. The operator is allowed to temporarily override this cutout to allow the boom to be moved back into a safe working region. Cutout Override ...
    • MCL - User - Overload/Override Modes

      System Indicators The MCL indicates the current status via the indicator mounted in the dashboard. Overload Indicator illustration below. Overload Mode When a load is lifted which is beyond the set capacity, the MCL system will go into overload mode. ...
    • Gen3_ITC - User - Cutout Override Control

      The Gen-3 safety system will engage the hydraulic cutout if the ITC is beyond it's recommended capacity The operator is allowed to temporarily override this cutout to allow the boom to be moved back into a safe working region. Below: Komatsu Override ...
    • ITC SWL- Hitachi & JCB - Cabin Electronics Installation

      The cabin electronics interface into the load sensor and produce the required cutout. Installation Steps: Install the indicator and override switch into a two spare housing in the dashboard. Below: Overload Indicator & Override Switch The switch ...
    • MCL - Installation - JCB Telehandlers Cabin Electronics Installation

      The cabin electronics interface into the load sensor and produce the required cutout. Installation Steps: 1. Install the indicator and override switch into a two spare slot, in the dashboard. The switch housing cutout in the dashboard may need to ...