Gen3 - Selections - Disable/Enable Forward/Reverse Camera (Old Display Software)

Gen3 - Selections - Disable/Enable Forward/Reverse Camera (Old Display Software)

Notes
Enabling/disabling cameras in older Gen 3 display software can be done by directly editing a configuration file on the SD card
Enabling/Disabling cameras in older display software versions requires a PC/Laptop, an SD card reader and the Windows 'Notepad' app. 
Steps to edit the relevant parameters:
1. Turn on and boot the computer
2. Insert the SD card from your telehandler into the card reader
3. On the SD card, locate the file:  data.cfg
4. On your PC, start the app: notepad.exe
5. Drag and drop data.cfg onto the open notepad page - image below represents some of what you will see.


6. The two parameters that require changes are: 
ForwardCameraEnabled= 
ReverseCameraEnabled=

A 1 or a 0 after the = will be entered/changed 
A 0 represents camera turned off
A 1 represents camera turned on

7.  Make the changes as required:

Disabling the forward camera

Enabling the forward camera


Disabling the rear camera


Enabling the rear camera


8. Save the changes by selecting File > Save


Select 'Save' to save the modified configuration



9. Eject the SD card and insert it back into the Gen 3 Display
When the Gen 3 next boots up, the camera(s) will either be enabled or disabled as edited in the data.cfg file.

Warning
Do NOT change any other parameters within the data.cfg file. Doing so may introduce gross inconsistencies and negate the Gen 3 abilities to be an effective safety system
    • Related Articles

    • Gen3 - Selections - Disable / Enable Forward Camera (Latest Software)

      Changing settings via the display was added in Display Version 1129. Check the current display version in the Status Menu. If the version is older then follow the instructions here to update the display. Press Enter on the user control dial to enter ...
    • Gen3 - Software - Commission Spare Display

      A spare display must be updated with the model specific configuration files before it can be used with an existing Gen3-LMS system. If the existing display is available swap over the SD card from the spare display. This will ensure that the sensor ...
    • Gen3 - Selections - 3 Tonne Limit (Old Display Software)

      Enabling/disabling 3 Tonne Limit in older Gen 3 display software can be done by directly editing a configuration file on the Gen 3 Display SD card Enabling/Disabling the 3 Tonne Limit in older display software versions requires a PC/Laptop, an SD ...
    • Gen3 - Selections - Disable / Enable Auto Tool Recognition

      Changing settings via the display was added in Display Version 1129. Check the current display version in the Status Menu. If the version is older then follow the instructions here to update the display. Press Enter on the user control dial to enter ...
    • Gen4 - Hardware - Reverse Camera

      The reverse camera video is displayed on the screen when the machine is in reverse gear. This device enables the operator to see behind the telehandler while reversing. Photo of rear camera mounted in position (on a Haulotte HTL4017) - with enlarged ...