Gen3 - Software - Custom Startup Splash Screen No Longer Supported

With the latest release of the Gen3 Display support for the customised splash screen during display startup also known as the boot or startup logo has had to be removed.

When using a new Gen3 Display applying a new Startup Logo using the Gen-3 Configuration Tool will have no effect

When starting the Gen3 Display the default splash screen below will be shown.

• Related Articles

• Gen3 - Software - Display Reset Loop On The EQSS Loading Screen

  It has come to our attention that an issue can occur with the Gen3 display that can prevent it from booting successfully and causing a reset loop. Reports indicate that this issue occurs randomly and may not occur at all. We've raised this issue with ...

• Gen4 - Attachments - Calibration Software Screen Descriptions

  The following sections describe the items in the 'Load Calibration Window' of the EQSS Gen 4 Load Calibration Software. Step Field This shows the current step in the calibration procedure for the attachment. The record point steps will be repeated ...

• Gen1 - Software - MPCT Calibrator Software

  Your Gen 1 Safety System must be calibrated using a laptop and EQSS calibration software before being put into service The MPCT Software is to be loaded on a laptop and is broken down into seven calibration sections and one configuration section. ...

• Gen3 - Software - Commission Spare Display

  A spare display must be updated with the model specific configuration files before it can be used with an existing Gen3-LMS system. If the existing display is available swap over the SD card from the spare display. This will ensure that the sensor ...

• Gen3_ITC - Software - Update Barminco ITC Display Software

  There are two versions of the ITC software for the Gen3-LMS. These instructions will apply the software for the Barminco range of machines. For all other ITC machines follow the Universal software instructions here. The following instructions will ...