Gen4 - Installation - Haulotte HTL 4014 Light Tower Installation

The light tower warns other workers when the telehandler is lifting loads close to its maximum capacity

Installation Steps:

1. Attach the light tower to the roof of the cabin using the nuts, screws, and washers’ supplies. 

2. The light tower cable will be connected during External Cable Completion.

• Related Articles

• Gen4 - Installation - Haulotte HTL 4017 Light Tower Installation

  The light tower warns other workers when the telehandler is lifting loads close to its maximum capacity Installation Steps: 1. Drill and tap two M5 holes in the location specified to mount the light tower bracket. 2. Attach the light tower to the ...

• Gen4 - Installation - Haulotte HTL 4014 Light Tower Cable

  This Tech Doc describes how to complete the Light Tower Cable Installation Installation Steps: 1. Feed the cable down the side of the cabin (as shown in the image below). 2. Connect the cable to the 3-pin connector labelled “Light Tower”.

• Gen4 - Installation - Haulotte HTL 4017 Light Tower Cable

  This Tech Doc describes how to complete the Light Tower Cable Installation Installation Steps: 1. Feed the cable down the side of the cabin (as shown below in the image). 2. Connect the cable to the 3-pin connector labelled “Light Tower”.

• Gen3 - Installation - Light Tower Installation

  The light tower warns other workers when the telehandler is lifting loads close to it's maximum capacity. The light tower should be mounted at the front of the telehandler in a location where it is visible to workers around the telehandler. It should ...

• SFPL - Installation - Generic Display Housing, Cable Reeler & Light Tower Installation

  Display Installation The display is housed within a IP67 rated enclosure and must be installed on the left side of the turret. The unit must be secured using four M6 bolts in each corner of the housing. Cable Reeler Installation The cable reeler is ...