Gen4 - User - Cameras
The Gen4-LMS has the ability to connect up to 3 cameras to improve the operator range of vision.
When a camera is
displayed, the boom position values and DST are shown overlaid at the bottom of the camera image and the zoomed
rating chart is shown in the quick view.
If a cutout or alarm occurs, or if the boom has been moved a significant distance, the camera will switch off to allow the
operator to see the main screen.
Forward camera – The forward or side wheel camera is displayed when the telehandler is in forward gear. It is positioned to show the view of the front right wheel, which is usually obstructed from the view of the operator by the boom (while performing a pick-and-carry lift). This allows the operator to see obstructions that will hit the front right tire while driving.
Reverse camera – This is displayed when the telehandler is in reverse gear. The camera shows obstructions that are
behind the telehandler - that the telehandler might hit when reversing.
Remote camera (optional) – This is activated by a switch in the dashboard. The remote camera is a wireless camera
that can be placed in a location to help the operator complete the lift. It can be mounted on the dogman's helmet to
allow the operator to see from the dogman's perspective, or it can be mounted on the attachment to allow the
operator to perform fine manoeuvres at long extensions (where it is difficult to see the attachment).
Related Articles
Gen3_ITC - User - Cameras
The Gen-3 safety system has the ability to connect up to 3 cameras to improve the operators' range of vision Below: Camera View on the Main Screen Display Reverse camera – This is displayed when the ITC is in reverse gear. The camera shows ...Gen3_ITC - User - Gen 3 Menu System
The menu system allows for configuring the Gen-3 system To enter the menu system, press the user control dial. This will display the main menu. To navigate through the menu options press the arrow buttons on the user control dial. The currently ...Gen3 - General - What is Gen 3 LMS?
The Gen3-LMS is a culmination of the current research and development efforts conducted by EQSS. The main purpose of the Gen3-LMS is to provide an additional level of safety when lifting both suspended and non-suspended loads. It is in effect a ...Gen1 - Installation Deici Icarus 40.17 Gen 1 to Gen 3 - User Input Control
The user input control switch is used to navigate the menus in the Gen3 LMS The user input control should be mounted in the dashboard in a location that is usable and visible to the operator. Drill a 34 mm hole into the dashboard to mount the switch. ...Gen3 - Hardware - 5 Button User Control switch
The 5 Button User Control switch must be plugged in to the Display for Gen 3 navigation to be possible 5 Button User Control switch assembly (Part No: SW001077) If you are not able to navigate the Gen 3 System then: 1. Check the physical connection ...