OverWatch - Software - Stabilisers failing test on Genie RT (Version 8 and lower)

OverWatch - Software - Stabilisers failing test on Genie RT (Version 8 and lower)

Notes
There are hidden buttons under the Genie RT decal required to pass Overwatch Installation tests
The Overwatch Installation test must be performed when an Overwatch kit is first installed on a Genie RT model. One of the final tests is the 'Stabilisers' sense test. Most people assume that the 'Auto Level' button should be pressed and detected by the Overwatch. However, there are hidden buttons under the wheels of the pictograph of the scissor base. When the test asks the operator to press the stabiliser button, then this is the button that it's asking for. Press any of the four wheels and the test should pass.

Below: Pictograph of the scissor base on the Genie RT control box

    • Related Articles

    • OverWatch - Installation - Genie RT Harness Soldering

      As part of the kit installation process, the Overwatch Genie RT harness requires some soldering This Tech Doc was not written as a step by step installation guide, but rather further guidance whilst following the actual published pdf installation ...

    • OverWatch - Software - Installation Test for Diesel (RT) Rough Terrain

      Rough Terrain machines with diesel engines must be running before attempting final Overwatch installation setup test Post Installation Configuration After the OverWatch has been installed, it must be configured with the parameters to suit the ...

    • OverWatch - Software - Installation Test (Software V9)

      Select MEWP & Run System Test Stand in front of the control box as though you are about to drive the MEWP. The sensor expects to see you at arms length. Power on the MEWP. When the OverWatch starts up, Overwatch Version 9 is announced, put the ...

    • OverWatch - Software - V9 Firmware Update and Installation Test

      Before applying the update, understand and ensure the following: Follow all steps in this procedure, exactly as written and in the correct order. If this procedure is not followed, the update will not be successful. Do not modify or deviate from this ...

    • OverWatch - Installation -Genie 2-Speed Lift Conversion

      If the control box has 2 speed lift then a Genie update is required Below: Photo of the affected Genie Control Box EQSS does manufacture an Overwatch kit for the following models: Scissors GS-1530 GS-1532 GS-1930 GS-1932 GS-2646 GS-4047 Masts GR-12 ...