OverWatch - User - Pre Operational Checks

The OverWatch™ is an electronic detection system and is an aid to the operator.

Before use, make sure that the system is in good working condition.

Conduct the following pre-operation checks.

• Related Articles

• Gen3 - User - Pre Operation Checks

  These tests must be performed in addition to the pre operation checks listed in the machine operator manual Run through the tests below before operating the machine.

• ITC SWL- User - Pre Operationial Checks

  Run through the tests below operating the machine. These tests must be performed in addition to the pre operation checks listed in the machine operator manual

• Crush Guard - User - Pre Operation Checks

  Run through the tests below before operating the machine. The procedure below tests the cutout and override mechanism of the Crush Guard®: These tests must be performed in addition to the pre operation checks listed in the machine operator manual

• OverWatch - User - Operational Instructions

  Warning: Risk of Severe Injury or Death if misused The OverWatch™ is an aid to the operator and this system should not in any way replace operator training. The system relies on optical detection principals and may not work in all situations and ...

• OverWatch - User - Visual & Audio Notifications

  The LED on the sensor and the sensor audio announcements (via speaker) are used to notify the user/operator OverWatch operational conditions Table of LED light codes and audio cues: