Model6254 Underwatch
Underwatch - Installation - ECU Module
This Tech Doc outlines the connections that need to be made to the machine Installation Steps: 1. Observe and take note of the harness information below 2. Splice grey wire into “Pedal dead man” wire X301-6. Wire should be +12V only when pedal and ...
Underwatch - Installation - Finalization
This Tech Doc was created to help finalize the Underwatch installation Installation Steps: 1. Connect the 8-Pin connector from the User Interface harness to the ECU 2. Connect the M12 screw lock connector to the User Interface Module. 3. Run the ...
Underwatch - Installation - User Interface
This Tech Doc was created to help install the User Interface 1. Install the User Interface in the location as shown below in the photos 2. Using the supplied M6 screws, washers, clamps, and nuts, install the user interface on the bar shown in the ...
Underwatch - Installation - Sensor Bars
This Tech Doc was created to help a competently trained technician, install and fit the sensor bars Installation Steps: 1. Position the Sensor Bar in the location under the basket (shown in the image below). 2. Mark the hole locations using the ...