Gen3 - Selections - Disable / Enable Forward Camera

Changing settings via the display was added in Display Version 1129. Check the current display version in the Status Menu. If the version is older then follow the instructions here to update the display.

1. Press Enter on the user control dial to enter the menu system.
   Press the arrow buttons to select System Menu.
   Press Enter to select the menu.
   
   
2. Select Advanced Menu
   
   
3. Enter the password
   (Default Password: 2-8-4)
   
   
   
4. Select Change Settings
   
   
5. Select Enable Forward Camera and use the arrow buttons to toggle between Off and On.
   Press the Enter button again to confirm the selection.
   
   
6. Restart the machine to load the new setting changes on the Gen3-LMS
   
   
7. Navigate to the Status Menu
   System Menu -> Status Menu
   
   
8. Check the value for Forward Camera shows the correct setting
   Note: May need to scroll down to the next page

• Related Articles

• Gen3 - Selections - Disable / Enable Auto Tool Recognition

  Changing settings via the display was added in Display Version 1129. Check the current display version in the Status Menu. If the version is older then follow the instructions here to update the display. Press Enter on the user control dial to enter ...

• Gen4 - Hardware - Forward Camera

  The forward or side wheel camera is displayed on the screen when the telehandler is in forward gear. It is positioned to show the view of the front right wheel, which is usually obstructed from the view of the operator by the boom while performing a ...

• Gen3 - Installation - Instructions to Disable Cutouts

  The Gen 3 system can be temporarily bypassed by disabling the cutouts. Each machine brand/model will have similar connection points, but will be located in different places on the machine. The easiest method of locating these places is to download ...

• Gen3 - Software - Enable and Setup Height Limiter

  The height limiter function in the Gen3-LMS is only compatible with certain machines. To determine if the machine supports the height limiter function goto System Menu -> System Tests and enable the Boom Raise Cutout and Boom Extend Cutout and see if ...

• Gen3 - Installation - Generic Camera Installation

  The Gen3-LMS has support for a forward and a reverse camera. The camera images are displayed on the screen when the machine is in drive. The forward camera is displayed when in forward gear and the reverse camera is displayed when in reverse gear. ...