Gen3_ITC - Installation - Caterpillar 962K EQSS CPIM Installation
The CPIM is responsible for processing the information sent from the pressure sensors the
articulation sensor and the RFID sensor
The CPIM also measures the chassis pitch and
roll with its internal angle sensors.
Installation Steps:
1. The location of the CPIM is shown in
the image below (within the red circle).
2. Drill two M8 holes for the CPIM
bracket in the position of the chassis (Shown in the photo below).
3. Ensure when marking mounting
location that there is enough room to
connect the cables.
4. Mount using the supplied
M8 bolts, nuts and washers.
5. Connect the cables for the pressure
sensors, Articulation sensor and
Angle sensors to the CPIM (as shown in the photo below).
Accidentally swapping the pressure sensor connections will
not damage the system
Do not plug the pressure sensor cable into the far right side
boom cable. This will damage the system.