Gen3_ITC - Installation - Volvo L120H & L90 EQSS CCIM Installation
The CCIM connects the system into the machine electronics
Installation Steps:
1. Mount the backup battery in the
location shown in the diagram using
the double sided velcro tape
attached to the base.
2. Slide the CCIM in the location shown
in the diagram
Related Articles
Gen3_ITC - Installation - Caterpillar 962K EQSS CCIM Module Installation
The CCIM connects the system into the machine electronics Installation Steps: 1. Mount the backup battery in the location (shown in the diagram below) using the double sided velcro tape attached to the base. 2. Slide the CCIM in the location shown in ...Gen3_ITC - Software - EQSS Gen 3 Configuration Tool
All end user capable configuration tasks are accomplished using the EQSS Gen 3 Configuration Tool The EQSS Gen 3 Configuration Tool is part of, and is automatically downloaded when the EQSS software suite is downloaded. The Tech Doc -- Gen3 - ...Gen3_ITC - Troubleshooting - Troubleshooting the Volvo ITC
Gen 3_ITC List of problems and Solutions on a Volvo ITC Problem: The boom won't move and the cutout icon is showing on the display Solution: You are trying to lift a load which is greater than the maximum capacity specified by the manufacturer rating ...Gen3_ITC - Installation - Volvo L120H Main Head & Rod Pressure Sensors
The hydraulic pressure sensors are used to measure the lifting load of the ITC Installation Steps: Completely lower the boom. Apply the handbrake and insert chock under wheels. Once lowered, release any residual pressure by pulling on the manual ...Gen3_ITC - Installation - Volvo L120H & L90 Boom Angle Sensor Installation
The Boom Angle Sensor is used to determine the inclination of the boom relative to the initially calibrated machine angle. Installation Steps: 1. Drill two M6 holes for the Angle Sensor in the position on the arm (shown in the diagram below). 2. ...