Gen3_ITC - Installation - Volvo L120H & L90 Cabin Loom

The cabin loom connects the CCIM to the machine connections and the other modules of
the system
1. Connect the power/camera and IO
harnesses to the CCIM bulk head
connectors.
2. Connect the reverse camera and
remote camera connectors to the
power/camera harness.
3. Run the 8 pin ‘CCIM to display’
cable, ‘User Control’ cable, ‘remote
camera/override’ cable and ‘Signal
Light’ cable through the Switch
column (as shown in the diagram below).
4. Connect the ‘Signal Light’ cable and
CPIM cable to either of the M12
connector on the CCIM.
5. Connect the 8 pin ‘CCIM to display’
cable and the 5 pin ‘User Control’
cable to the 8-pin and 5 pin
connectors on the back of the
display.
6. Connect the male spade to the back
of the remote and override camera switch as following:
Install switches into post once
connections are complete.
Below: Photo of Switches

If the M12 screw lock connectors on the display are over
tightened it will twist (and probably short) the connector pins attaching the
connector to the PCB

Do not disconnect the camera power connection while the
system is operating as this can damage the fuse
Related Articles
Gen3_ITC - Installation - Caterpillar 962K Cabin Loom Installation
The cabin loom connects the CCIM to the machine connections and the other modules of the system Installation Steps: 1. Connect the power/camera and IO harnesses to the CCIM bulk head connectors. 2. Connect the ‘Signal Light’ cable and CPIM cable to ...
Gen3_ITC - Troubleshooting - Troubleshooting the Volvo ITC
Gen 3_ITC List of problems and Solutions on a Volvo ITC Problem: The boom won't move and the cutout icon is showing on the display Solution: You are trying to lift a load which is greater than the maximum capacity specified by the manufacturer rating ...
Gen3_ITC - Installation - Volvo L120H Main Head & Rod Pressure Sensors
The hydraulic pressure sensors are used to measure the lifting load of the ITC Installation Steps: Completely lower the boom. Apply the handbrake and insert chock under wheels. Once lowered, release any residual pressure by pulling on the manual ...
ITC SWL- Hitachi & JCB - Cabin Electronics Installation
The cabin electronics interface into the load sensor and produce the required cutout. Installation Steps: Install the indicator and override switch into a two spare housing in the dashboard. Below: Overload Indicator & Override Switch The switch ...
Gen3_ITC - Installation - Volvo L120H & L90 Signal Light Installation
The signal light warns other workers when the ITC is lifting loads close to it's maximum capacity. Installation Steps: 1. Drill and tap four M4 holes to mount the signal light bracket to the left side of the cabin roof (as shown in the photo below). ...