Gen3_ITC - Installation - Volvo L120H & L90 Installation Finalisation
This Tech Doc will complete the final power connections to power the system and finish any additional items
Installation Steps:
1. Connect the 3 pin connector from
the “24V to 12V converter” to the
power/camera harness. Make
sure that the 24V to 12V
converter power switch is set to
ON.
2. Connect the 6-Pin connector from
the ‘machine cutout’ harness to
the IO harness.
Connect the 12-pin, 4-pin and 2-pin connectors from the Remote
Camera/override harness to the IO
harness.
3. Connect the spade lug on the
black wire to the negative (black)
battery terminal.
Connect the spade lug on the blue
wire to the positive (red) battery
terminal.
4. Slide the CCIM back into it’s
designated position and then
fasten the 24V to 12V converter
in the position shown in the
diagram using the supplied Velcro
strips.
5. Coil up the extra cables and store
in the gap above the 24V to 12V
converter.
6. De-activate the battery isolation.
Turn the machine onto first
stage /accessories and ensure the
system is activated.
7. Adjust the display bracket for
optimal viewing. Set the machine into reverse gear
to activate the reverse camera.
Adjust the reverse camera so the
video is level.
8. Perform a final check on all the
cabling and sensors.
9. Replace all the covers.
Some machines had wiring modifications applied by the end user and may not match the wiring in this Tech Doc
Complete the system checklist once installation has been
completed
Related Articles
Gen3_ITC - Installation - Volvo L120H Main Head & Rod Pressure Sensors
The hydraulic pressure sensors are used to measure the lifting load of the ITC Installation Steps: Completely lower the boom. Apply the handbrake and insert chock under wheels. Once lowered, release any residual pressure by pulling on the manual ...Gen3_ITC - Installation - Volvo L120H & L90 Boom Angle Sensor Installation
The Boom Angle Sensor is used to determine the inclination of the boom relative to the initially calibrated machine angle. Installation Steps: 1. Drill two M6 holes for the Angle Sensor in the position on the arm Shown in the diagram. 2. Mount the ...Gen3_ITC - Installation - Caterpillar 962K Installation Finalisation
This Tech Doc will complete the final power connections to power the system and finish any additional items Installation Steps: 1. Connect the 3 pin connector from the “24V to 12V converter” to the power/camera harness. And make sure that the 24V to ...Gen3_ITC - Installation - Volvo L120H & L90 Articulation Sensor Installation
The articulation sensor is mounted mid machine at the point of machine articulation Installation Steps: 1. Drill two M6 holes for the Articulation base plate in the location shown, using the plate as a guide to mark the M6 hole locations. Make sure ...Gen3_ITC - Installation - Volvo L120H & L90 Display Installation
The display shows the current safety status of the ITC. Installation Steps: Position the display bracket at the top left of the Switch Column. Drill two M6 holes to attach the bracket to the Switch Column. Secure the bracket to the switch column ...