Gen3_ITC - Installation - Volvo L120H & L90 Man Platform Cameras Installation
The Man Platform camera’s are displayed on the screen when the Man Platform is
connected.
Installation Steps:
1. Feed approximately 2m of the cable
with the 6 pin connector side from
the outside through the cabin entry
grommet.
2. Route the cable along the path
shown in the diagram to prevent
tension on cable during movement of
front end during steering.
3. Route cable along existing hosing,
up to the front of the machine
securing with cable ties.
The camera's viewing angle may need to be adjusted once the
system is installed and the display is operational.
Do not disconnect the camera power connection while the
system is operating as this can damage the fuse.
Related Articles
Gen3_ITC - User - Cameras
The Gen-3 safety system has the ability to connect up to 3 cameras to improve the operators' range of vision Below: Camera View on the Main Screen Display Reverse camera – This is displayed when the ITC is in reverse gear. The camera shows ...Gen1 - User - Man Platform Operations
When the man platform has been attached to the telehandler, the range of movement is limited to 3 meters height and 5 meters radius while the stabilizers are up. If these limits are exceeded the cutout will engage. The cutout generated for a man ...Gen3_ITC - Installation - Volvo L120H Main Head & Rod Pressure Sensors
The hydraulic pressure sensors are used to measure the lifting load of the ITC Installation Steps: Completely lower the boom. Apply the handbrake and insert chock under wheels. Once lowered, release any residual pressure by pulling on the manual ...Gen3_ITC - General - What is a GEN 3 ITC?
This system has been designed specifically for use with Integrated Tool Carriers (ITC) to cover all relative national and international safety standards. This Tech Doc details system specifications, system functionality, installation requirements, ...Gen3_ITC - Troubleshooting - Troubleshooting the Volvo ITC
Gen 3_ITC List of problems and Solutions on a Volvo ITC Problem: The boom won't move and the cutout icon is showing on the display Solution: You are trying to lift a load which is greater than the maximum capacity specified by the manufacturer rating ...