Gen3_ITC - Installation - Volvo L120H & L90 RFID Tag Installation
Each tool contains it’s own individual RFID tag, which will communicate with the RFID
reader.
This installation allows the system to determine which tool is currently active and will
outline the location on each tool where the RFID bracket will be mounted.
The RFID tags are programmed at EQSS. When you want to order an RFID tag, you will also need to let us know on which attachment it will be mounted.
Installation Steps:
1. Weld the base of the RFID tag
bracket in the location shown in the
diagram next to each tool.
Make sure the RFID tag is facing
toward the reader.
Each RFID tag is different. Make
sure the associated RFID tag is
installed on the correct tool.
2. JIB
3. FORKS
4. BASKET
5. BUCKET
Related Articles
Gen3_ITC - Installation - Volvo L120H & L90 RFID Reader Installation
The RFID reader is the machine’s communication point for the automated tool recognition system. Installation Steps: 1. Drill two M6 holes in the position shown in the diagram below and install the RFID reader using the supplied M6 screws and washers. ...Gen3_ITC - Attachments - Automatic Recognition Installation
ITC AUTOMATIC TOOL RECOGNITION - Installation Instructions Connection Layout: CAN Module Installation: RFID Reader Installation: RFID Tag Installation:Gen3_ITC - Installation - Volvo L120H Main Head & Rod Pressure Sensors
The hydraulic pressure sensors are used to measure the lifting load of the ITC Installation Steps: Completely lower the boom. Apply the handbrake and insert chock under wheels. Once lowered, release any residual pressure by pulling on the manual ...Gen3_ITC - Faults - Debugging RFID Reader
When automatic tool selection is enabled on the Gen3-LMS, the system uses the RFID reader on the tool coupler and ID tags on the tools to identify the attachment in use. If the tool or attachment is connected to the machine, but the Gen3-LMS is ...Gen3_ITC - Troubleshooting - Troubleshooting the Volvo ITC
Gen 3_ITC List of problems and Solutions on a Volvo ITC Problem: The boom won't move and the cutout icon is showing on the display Solution: You are trying to lift a load which is greater than the maximum capacity specified by the manufacturer rating ...