Gen3_ITC - Fault Code - IN13
The Relays in the CCIM are monitored for reliable activation
The CCIM provides the interface between the machine electrics and the EQSS technology and it also controls machine cutouts via internal relays. As the Gen 3 system is a safety system and the cutout relays are monitored to ensure reliable operability of cutouts.
When an IN13 fault code is displayed, the system has determined that the CCIM Output 2 Relays have developed a fault.
Possible reasons are:
- CCIM Output 2 Relay Fault or Conflict
- The Output 2 cutout relay in the CCIM has failed to energise.
As stated above, the EQSS CCIM switches cutouts with mechanical relays. As the EQSS system is a safety system, those relays are monitored by the electronics. During the operation of the ITC machine, the relays are monitored for integrity. If the electronics sense that these relays will fail to create an effective cutout at Output 2, they display an IN13 fault code.
There are no user serviceable parts inside the CCIM. Therefore, the CCIM must be repaired in order to continue to be an effective safety device.
Contact your local EQSS representative to repair or replace the CCIM
Related Articles
Gen3_ITC - Fault Code - All Gen 3 Fault codes
Gen 3 Fault codes are displayed in Red color and are displayed on the Gen 3 operator screen To further identify the fault (via the Gen 3_ITC Display), enter the Menu System, then select System Faults. This will display a list of the current system ...Gen3_ITC - Fault Code - IT05
This fault code can appear when the Gen 3 ITC is not able to write to the SD card. There are two common causes for this error code: 1. Write Lock Tab on the SD card has been set to 'Locked'. 2. SD card carrier in the EQSS Display unit is faulty. ...Gen3_ITC - Fault Code - IT09
This fault code can appear with a fresh Gen 3 install or when a CCIM has been replaced. The EQSS CCIM uses PCB mounted DIP switch banks for forward/reverse ITC drive logic settings. These settings are configured at the factory and can be ITC ...Gen3_ITC - Fault Code - IT02
The EQSS Gen 3 ITC kit contains a sensor that monitors the vehicle articulation angles The Gen 3 articulation angle sensor is used by the EQSS system to gather vehicle articulation data as part of the machine's weight lift capacity calculations. If a ...Gen3_ITC - Fault Code - IT01
Boom Angle is calibrated during the initial kit install The Boom Angle Sensor is used to determine the inclination of the boom relative to the initially calibrated machine angle. The IT01 fault code signifies: Boom Angle Out of Range The boom angle ...