Gen3_ITC - Fault Code - IT02

Gen3_ITC - Fault Code - IT02

Notes
The EQSS Gen 3 ITC kit contains a sensor that monitors the vehicle articulation angles
The Gen 3 articulation angle sensor is used by the EQSS system to gather vehicle articulation data as part of the machine's weight lift capacity calculations. If a sensor fault/misalignment occurs, then an IT02 fault code will be displayed on the screen.
Possible causes:
  1. Articulation Angle Out of Range
  2. The angle of articulation has exceeded the defined range
Troubleshooting:
Articulate the ITC left and right and make sure the angle is changing. If the angle is changing, re-calibrate the articulation angle sensor. If the angle does not change then check all articulation sensor wiring.

Info
If the problem remains after sensor calibrations have been completed, contact EQSS for a replacement articulation sensor. 

    • Related Articles

    • Gen3_ITC - Fault Code - All Gen 3 Fault codes

      Gen 3 Fault codes are displayed in Red color and are displayed on the Gen 3 operator screen To further identify the fault (via the Gen 3_ITC Display), enter the Menu System, then select System Faults. This will display a list of the current system ...

    • Gen3_ITC - Fault Code - IT05

      This fault code can appear when the Gen 3 ITC is not able to write to the SD card. There are two common causes for this error code: 1. Write Lock Tab on the SD card has been set to 'Locked'. 2. SD card carrier in the EQSS Display unit is faulty. ...

    • Gen3_ITC - Fault Code - IT09

      This fault code can appear with a fresh Gen 3 install or when a CCIM has been replaced. The EQSS CCIM uses PCB mounted DIP switch banks for forward/reverse ITC drive logic settings. These settings are configured at the factory and can be ITC ...

    • Gen3_ITC - Fault Code - IT01

      Boom Angle is calibrated during the initial kit install The Boom Angle Sensor is used to determine the inclination of the boom relative to the initially calibrated machine angle. The IT01 fault code signifies: Boom Angle Out of Range The boom angle ...

    • Gen3_ITC - Fault Code - IN06

      The CDAM is a CAN bus device and it passes ITC arm/boom angle information to the rest of the EQSS system The Boom Angle Sensor is used to determine the inclination of the boom relative to the initially calibrated machine angle. Some possible reasons ...