Gen3_ITC - Installation - Volvo L120H & L90 User Input Control
The user input control consists of a single dial switch mounted in the side console
Installation Steps:
- Drill two M4 through-holes for the
User Control Bracket in the location
on the centre console (as shown in
the photo below).
- Mount the bracket using the supplied
M4 screws, washers and nuts.
- Feed the wire from the 5 button user
control through the bracket
- Install the user control onto the
bracket.
Related Articles
Gen3_ITC - User - User Input Control
The operator will be required to select different configuration options for the safety system, such as changing the attachment selection. This is accomplished by the user input control switch. The user input control switch has 3 functions: increment ...Gen3_ITC - Installation - Caterpillar 962K User Input Control (Navigation Switches)
The user input control consists of a 5-way navigation switch mounted in the side console Installation Steps: Drill two M4 through-holes for the User Control Bracket in the location on the centre console as shown in the diagram. Mount the bracket ...Gen1 - Installation Deici Icarus 40.17 Gen 1 to Gen 3 - User Input Control
The user input control switch is used to navigate the menus in the Gen3 LMS The user input control should be mounted in the dashboard in a location that is usable and visible to the operator. Drill a 34 mm hole into the dashboard to mount the switch. ...SFPL - User - User Input Control
The user control dial is used in order to access the menu to perform diagnostics. To access the user control dial, release the two bolts holding the enclosure lid. Slightly open the lid to control the user dial. The user input control dial has 3 ...Gen3 - User - User Input Control
The User Input Control mounting is Telehandler dependent and can be found in one of multiple locations within a cab. Below are some common mounting positions: The user input control switch has 3 functions: increment up, increment down and select. ...