Model6286 Gen4
Gen4 - User - Override
The Gen4-LMS will engage the hydraulic cutout if the telehandler is beyond it's recommended capacity. The operator is allowed to temporarily override this cutout in order to allow the boom to be moved back into a safe working region. See the machine ...
Gen4 - User - Cameras
The Gen4-LMS has the ability to connect up to 3 cameras to improve the operator range of vision. When a camera is displayed, the boom position values and DST are shown overlaid at the bottom of the camera image and the zoomed rating chart is shown in ...
Gen4 - User - Quick View
The quick view area contains specialized information. Each quick view page is displayed in the following section: Dynamic Stability Triangle (DST) The stability triangle shows the current center of mass of the telehandler, taking into account the ...
Gen4 - User - Rating Chart
The rating chart window displays the current rating chart for the selected attachment and the stabilizer configuration. The load segments on the rating chart are color coded to match the current load. If the segment is green and the boom was moved ...
Gen4 - Attachments - Specific Attachments
There are special use cases to be aware of when using specific types of attachments with the Gen4-LMS system. Please be aware of the following: Long Reach Attachments When using attachments that have a long reach such as a long boom or fly jib/winch, ...
Gen4 - Attachments - Attachment Menu
The attachment selection menu is accessible by pressing the change attachment button in the bottom right corner on the attachment description on the main screen. The change attachment button is highlighted below. Once the new attachment is selected ...
Gen4 - User - Screen Layout
The Gen4-LMS is operated and controlled from the touchscreen display mounted inside the cabin. Main screen illustration and descriptions below: Menu Press this button to access the menu system. Chart This shows the rating chart for the currently ...
Gen4 - User - Pre Operation Checks
Run through the tests below before operating the machine.
Gen4 - Fault Codes - External Fault Tests
The Gen4-LMS has over 100 fault codes which can be generated by the safety calculation processes. The majority of these faults occur during a hardware failure and can only be tested via software simulation (or by physically damaging the components). ...
Gen4 - General - What is Gen 4 LMS?
Hardware Overview Display The Model 6205 Display Module is the main HMI device for the Gen4-LMS. It is used to display information to the operator. It contains a built in touch screen to allow the operator to interact with the system, and dual audio ...