Model6287 Gen3 ITC
Gen3_ITC - Fault Code - Status Icons
The top right of the main window below the capacity bar holds the location of the status icons. Below is a description of each status icon: The icon status can only display 3 icons. If more than 3 icons are enabled the 3 most important icons are ...
Gen3_ITC - Software - Update Universal ITC Display Software
There are two versions of the ITC software for the Gen3-LMS. These instructions will apply the Universal software. If the machine is owned by Barminco follow the instructions here. The following instructions will describe copying an update file to ...
Gen3_ITC - Software - Update Barminco ITC Display Software
There are two versions of the ITC software for the Gen3-LMS. These instructions will apply the software for the Barminco range of machines. For all other ITC machines follow the Universal software instructions here. The following instructions will ...
Gen3_ITC - Calibration - Determining Boom Angle Zero on ITC
When calibrating the boom angle on an ITC for the Gen3-LMS, the boom must be raised up 0 degrees. For an ITC the boom angle is at 0 degrees when the boom/chassis pivot pin and boom/head pivot pin are at the same height off the ground. Move the ITC to ...